
Melt Pressure Transducer Simulator
The Terwin pressure transducer simulator has been designed as a service aid to engineers that are involved in the extrusion of plastics, rubber and food.
Should a fault occur on an extrusion pressure monitoring / control system, the simulator will enable the plant engineer to check the cable assembly and associated indicator / controller / signal conditioner by simply plugging the transducer cable assembly into the simulator and checking all the functions with the eleven point rotary switch.
Data Sheet
Should a fault occur on an extrusion pressure monitoring / control system, the simulator will enable the plant engineer to check the cable assembly and associated indicator / controller / signal conditioner by simply plugging the transducer cable assembly into the simulator and checking all the functions with the eleven point rotary switch.
Data Sheet
- Accuracy ±0.25%
- Full Scale Output Nominal 3mV/V
- Configuration 350 ohm Wheatstone bridge
- Input Resistance 350 ohm ±0.5%
- Output Resistance 350 ohm ±0.5%
- Range 0-100% of F.R.O. in 10% steps
- Zero Balance ±0.25% of F.R.O.
- Calibration Type 6-wire 80% Negative Shunt
- Excitation 5 – 12V D.C.
Data Sheet